Construction Technology of LED Purification Lamp
Release time:2019-10-04 source:
Installation instructions for cleaning lamps
I. Major Classifications:
Roof-suction Purification Lamps and Embedded Purification Lamps
II. Auxiliary materials:
Expansion pipe, wood screw, electrical rubber, rivet.
3. Main machines and tools:
Pencils, tapes, gloves, stripping pliers, flat tongs, pointed tongs, one-word tapers, cross tapers, wrenches, drills, pens, benches, rivet guns, etc.
4. Installation requirements:
1. Lamps and fittings should be complete, and there should be no obvious mechanical damage, deformation and lampshade rupture defects.
2. The bearing capacity of fixtures on the ceiling mounted with lamps should be matched with the weight of lamps.
3. Electricity test should be carried out before the lamp is installed to confirm that the lamp can be lit.
4. Make sure that the power supply is disconnected before installation.
5. Installation of ceiling-suction cleaning lamps and lanterns:
1. Remove the cover and reflector of the purifying lamp;
2. Place the base of the purifying lamp on the top surface, and draw the position of the hole with pencil, including four fixed holes and one wire entry hole.
3, the power cord is put into the light box.
4. Drill holes with an electric drill, then fix the cleaning lamps on the top surface with rivets or expansion tubes and wood screws.
5. The power line is connected with the inlet line of the purify lamp, the red is the firing line, and the green is the zero line.
6. Fix the reflex plate of the purified lamp on the lamp, adjust the straightness, tear off the protective film and install the lamp tube.
7. Finally, install the outer cover of the purifying lamp.
6. Points for attention in the installation of emergency devices:
1. When installing purifying lamps and lanterns, the wiring must be as follows: red wiring, green wiring, zero wiring; red wiring and green wiring are strictly prohibited to install switches.
2. Under the yellow wire connection switch, the pile head (power-off side) is connected with the red wire in-phase fire line on the top of the switch.
3. Switches only control normal lighting, but not emergency lighting.
4. It is strictly forbidden to turn on the yellow line when the red line is cut off. Under this condition, the emergency power supply device is easily damaged.
5. It must be charged 24 hours before use, and no-load (no light source) state is strictly prohibited in case of emergency.
6. The nickel-cadmium batteries stored in emergency lighting lamps are automatically charged and discharged without special monitoring.
7. Life of 500 cycles of charging and discharging is scrapped, so the phenomenon of man-made blackout should be avoided as far as possible.
Shandong aide purification engineering Limited by Share Ltd has strong technical strength and construction experience. According to the different needs of cleanliness, we use professional equipment to form clean standard space of different grades to create the most suitable production and working environment. At present, it has established close cooperation with many enterprises and is a trustworthy professional purifying project implementer. For more knowledge of medical purification industry, please pay attention to the public address: Aide-188 (Ed purify oxygen supply).